Vi tilbyr in-house sertifisert teknisk service
Solid leverandør med over 50 års erfaring i bransjen og ansatte med høy teknisk ekspertise
Stort varelager og fleksible leveringsalternativer
| RF Carrier Frequency Range | 470–937.5 MHz, varies by region (See Frequency Range and Output Power table) |
| Working Range | 100 m ( 328 ft) |
| RF Tuning Step Size | 25 kHz, varies by region / JB band: 125 kHz |
| Image Rejection | >85 dB, typical |
| RF Sensitivity | −97 dBm at 10-5 BER |
| Operating Temperature Range | -18°C (0°F) to 50°C (122°F) |
| Storage Temperature Range | -29°C (-20°F) to 74°C (165°F) |
| Latency | 2.8 ms |
| High-Pass / Low Cut Filter | 160 Hz @ -12 dB/octave |
| Audio Dynamic Range | 118 dB at 1% THD, A-weighted, typical |
| Total Harmonic Distortion | <0.02% |
| System Audio Polarity | Positive pressure on microphone diaphragm produces positive voltage on pin 2 with respect to pin 3 of XLR output, and the tip of the 6.35 mm (¼ in.) with respect to the ring of the 6.35 mm output. |
| Mic Offset Range | 0 to 21 dB (in 3 dB steps) |
| Frequency Range | 2402–2480 MHz |
| RF Power | 10 mW EIRP |
| Modulation Type | BLE (GFSK) |
| Antenna Type | Chip |
| Antenna Gain | -0.7 dBi |
| Dimensions | 42 x 393 x 152 mm (1.65 x 15.47 x 5.98 in.), H x W x D |
| Weight | 1750 g, without antennas |
| Housing | Galvanized Steel |
| Power Requirements | |
| Maximum power draw with Dante | 15 V at 1030 mA |
| Maximum power draw without Dante | 15 V at 900 mA |
| RF Input | |
| Spurious Rejection | >75 dB, typical |
| Connector Type | BNC |
| Impedance | 50 Ω |
| Bias Voltage | 15 V DC, 150 mA maximum, per antenna / switchable on-off |
| Audio Output | |
| Audio Frequency Response | 20 Hz– 20 kHz (+1, -2 dB) |
| Gain Adjustment Range | -18 to +42 dB in 1 dB steps |
| Configuration 1/4" (6.35 mm) | Balanced (Tip = audio +, Ring = audio -, Sleeve = ground) |
| Configuration XLR | Balanced (1=ground, 2=audio +, 3=audio −) |
| Impedance 1/4" (6.35 mm) | 1.1 kΩ (550 Ω Unbalanced) |
| Impedance XLR (line) | 500 Ω (250 Ω Unbalanced) |
| Impedance XLR (mic) | 150 Ω |
| Full Scale Output 1/4" (6.35 mm) | +12 dBV Unbalanced, +18 dBV Balanced |
| Full Scale Output XLR | LINE setting= +18 dBV, MIC setting= -12 dBV |
| Mic/Line Switch | 30 dB pad |
| Phantom Power Protection 1/4" (6.35 mm) | Yes |
| Phantom Power Protection XLR | Yes |
| Cascade Output | |
| Connector Type | BNC |
| Note | For connection of one additional receiver in the same band |
| Configuration | Unbalanced |
| Impedance | 50 Ω |
| Insertion Gain | 0–2 dB, typical |
| Networking | |
| Network Interface | 10/100 Mbps, 1 Gbps, Dante Digital Audio |
| Network Addressing Capability | DHCP or Manual IP address |
| Maximum Cable Length | 100 m (328 ft) |
| SLXD1+ Bodypack Transmitter | |
| Battery Type | Rechargeable Li-Ion or 1.5 V AA batteries |
| Dimensions | 98 x 68 x 25.5 mm (3.86 x 2.68 x 1 in.), H x W x D |
| Weight | 89 g |
| Housing | PC/ABS |
| Audio Input | |
| Connector | 4-Pin male mini connector (TA4M) |
| Configuration | See drawing for details |
| Impedance | 1 MΩ |
| Maximum Input Level | 8.2 dBV (2.57 Vrms, 7.27 Vpp) |
| Preamplifier Equivalent Input Noise (EIN) | -118 dBV |
| RF Output | |
| Antenna Type | 1/4 wave |
| Occupied Bandwidth | <200 kHz |
| Modulation Type | Shure proprietary digital |
| Power | 1 mW or 10 mW / See Frequency Range and Output Power table, varies by region |
| Battery Type | Rechargeable Li-Ion or 1.5 V AA batteries | |
| Battery Type | Rechargeable Li-Ion or 1.5 V AA batteries | |
| Battery Type | Rechargeable Li-Ion or 1.5 V AA batteries |
| Dimensions | 37.1 x 176 mm (1.46 x 6.93 in.), D x L |
| Weight | 144 g |
| Housing | Aluminum |
| Audio Input | |
| Configuration | See drawing for details |
| Maximum Input Level | 8.2 dBV (2.57 Vrms, 7.27 Vpp) |
| Note | Dependent on microphone type |
| RF Output | |
| Antenna Type | Integrated Single Band Helical |
| Occupied Bandwidth | <200 kHz |
| Modulation Type | Shure proprietary digital |
| Power | 1 mW or 10 mW |
| Battery Type | Rechargeable Li-Ion or 1.5 V AA batteries |
| Dimensions | 37.1 x 176 mm (1.46 x 6.93 in.), D x L |
| Weight | 144 g |
| Housing | Aluminum |
| Audio Input | |
| Configuration | See drawing for details |
| Maximum Input Level | 8.2 dBV (2.57 Vrms, 7.27 Vpp) |
| Note | Dependent on microphone type |
| RF Output | |
| Antenna Type | Integrated Single Band Helical |
| Occupied Bandwidth | <200 kHz |
| Modulation Type | Shure proprietary digital |
| Power | 1 mW or 10 mW |
| Charge Current | 625 mA or 250 mA / Lower current used when using another power source, or operating between 0℃ and 10℃ |
| Charge Time | 50% = 1 hour : 15 minutes; 100% = 2 hours : 30 minutes |
| External Power Supply | SBC10-USB15W or SBC10-USB15WS |
| Power Requirements | 5 V DC, 3 A max. |
| Operating Temperature Range | 0 °C to 45 °C (32 °F to 113 °F) |
| Dimensions | 66.3 x 86.0 x 155 mm (2.61 x 3.38 x 6.13 in.), H x W x L |
| Weight | 284 g |
| Housing | ABS |
| Microphone Capsule | MEMS |
| Polar Pattern | Omnidirectional |
| Frequency Response | 20 Hz to 20 kHz |
| Sensitivity | –42.5 dBV (7.5 mVRMS) @ 1 kHz |
| Self-Noise | 31 dB SPL-A, A-weighted, Equivalent Acoustical |
| Signal-to-Noise Ratio | 63.0 dB |
| Maximum SPL | 132.0 dB SPL, 1 kHz @ 1% THD, typical |
| Dynamic Range | 101.0 dB, Typical |
| Microphone Current Draw | 220 µA, maximum |
| Bias Voltage Recommended Operating Voltage | 5 VDC |
| Housing | Molded ABS |
| Polarity | MTQG: Positive Pressure on diaphragm produces positive voltage on Pin 3 with respect to Pin 1 / LEMO: Positive pressure on diaphragm produces positive voltage on Pin 3 with respect to Pin 1 |
| Cable Diameter | 1.6 mm |
| Cable Length | 66.0 in (1.67 m) |
| Net Weight | 20 g (0.7 oz) |
| Capsule Dimensions (L × D) | 14.5 mm × 5.2 mm |
| Boom Length | 13.6 cm |
| SKU | BEN-SLXD+4D |
|---|---|
| Vekt (kg) | 0.000000 |
| Enhet | Stk |
| Fabrikant | Shure |
| Produktserie | SLX-D+ |
| Produkttype | Trådløst system |
| Konfigurasjon | Rack 1U |
| Mikrofon Karakteristikk | Kardioid |
| Antall kanaler | 4 kanaler |
| AoIP / Protokoll | Dante |
| Farge | Svart |
Fyll inn skjemaet, så kontakter vi deg
Kun bedrifter med gyldig bransjetilknytning og organisasjonsnummer kan søke om tilgang.
Typiske kunder er forhandlere av musikkinstrumenter og forbrukerelektronikk, AV-firmaer, lydstudio, installatører, PA-firma, broadcast og film-/videostudio.
Vurderingen av kundeforhold gjøres manuelt, og vi vil gjennomføre en kredittsjekk av ditt firma eller enkeltpersonsforetak. Behandlingstid er normalt 2-4 dager.
Som bedriftens admin kan du legge til flere brukere for ditt firma.
Ved første gangs innlogging på våre nettsider, klikk på "Glemt passordet?" for å få tilsendt passord.
Dersom du har problemer med innlogging kan du ta kontakt på norway@benum.com.
Kjøp på benum.no er regulert av kjøpsloven.